Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
filereference:output:pollutants [2020/07/21 15:23] – added descriptions enviadmin | filereference:output:pollutants [2021/11/11 20:09] (current) – enviadmin | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Output Files: Pollutants (_POLU_) ====== | ====== Output Files: Pollutants (_POLU_) ====== | ||
+ | <fs smaller> | ||
+ | </fs> | ||
- | //***Work in Progress...***// | + | <WRAP box left 99%> |
- | + | ||
- | + | ||
- | <WRAP box left 80%> | + | |
<WRAP box left 40%> | <WRAP box left 40%> | ||
^ Dimension ^ Nr Variables ^ Format ^ | ^ Dimension ^ Nr Variables ^ Format ^ | ||
Line 12: | Line 11: | ||
**PollutantData** | **PollutantData** | ||
- | Contains the pollutant data within the model area for every simulation output. | + | Contains the pollutant data within the model area for every simulation output. Note that the pollutant data is only written if the model area includes sources. |
- | Note that the pollutant data is only written if the model area includes sources. | + | |
</ | </ | ||
+ | <WRAP clear></ | ||
+ | The pollutant data files are produced each main output interval (default: 60 min) and represent the general state and distribution of the pollutants at the given model time. | ||
- | <WRAP clear></ | + | If Water Spray is used, although modelled through a pollutant |
- | + | ||
- | The pollutant | + | |
- | <WRAP box left 80%> | + | <WRAP box left 99%> |
==== Variable list ==== | ==== Variable list ==== | ||