A holistic microclimate model

You are here: Technical Model Webpage » filereference » ENVI-met Output Files » Output Files: Atmosphere data (_AT_)

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
filereference:output:atmosphere [2021/11/11 20:35] – enviadminfilereference:output:atmosphere [2021/11/12 08:41] – enviadmin
Line 1: Line 1:
 ====== Output Files: Atmosphere data (_AT_) ====== ====== Output Files: Atmosphere data (_AT_) ======
-<fs smaller>[[filereference:output:start|← go back to Output File Index]], **See also:** () + 
-</fs>+ 
 +<WRAP tabs> 
 +  * [[filereference:output:start|← go back to Output File Index]] 
 +  * [[filereference:output:surface|see also: Surface Files]] 
 +  * [[filereference:output:soil|see also: Soil Files]] 
 +</WRAP>
  
 <WRAP box center 99%> <WRAP box center 99%>
Line 20: Line 25:
 Note, that the surface data are not part of the atmosphere data, but of the [[filereference:output:surface|Surface/ Flux (_FX_) files]]. Note, that the surface data are not part of the atmosphere data, but of the [[filereference:output:surface|Surface/ Flux (_FX_) files]].
    
-If you use Water Spray in your simulation, the data on the spray distribution and coolimg effect are also stored in this file.+If you use Water Spray in your simulation, the data on the spray distribution and cooling effect are also stored in this file.
  
 <WRAP box center 99%> <WRAP box center 99%>