A holistic microclimate model

You are here: Technical Model Webpage » [CLOUDS]-Section

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision		Previous revision
Last revisionBoth sides next revision
clouds [2012/06/30 19:41] – created 134.93.180.188clouds [2012/07/06 18:43] – [Purpose] 134.93.180.188
Line 4: Line 4:
  Normally ENVI-met is run for cloud-free sky conditions as in this situation the spatial and temporal differences can be observed best. However, there may be a demand to run ENVI-met also with the assumption of an existing cloud cover.   Normally ENVI-met is run for cloud-free sky conditions as in this situation the spatial and temporal differences can be observed best. However, there may be a demand to run ENVI-met also with the assumption of an existing cloud cover. 
  
-To include clouds in your simulation, use the [CLOUDS]-Section:+**To include clouds in your simulation, use the [CLOUDS]-Section:**
  
 <file> <file>
Line 19: Line 19:
 === 01-03: Fraction of Cloud Cover in LOW, MEDIUM and HIGH Layer (Default 0/8) === === 01-03: Fraction of Cloud Cover in LOW, MEDIUM and HIGH Layer (Default 0/8) ===
 Give the fraction of clouds in x/8 for each layer.  Give the fraction of clouds in x/8 for each layer. 
-The sum fraction of all layers cannot be higher than 8/8 ! +The sum fraction of all layers cannot be higher than 8/8!
- +
- +
  
 +===== =====
 +\\
 //**Warning:** //**Warning:**