A holistic microclimate model

You are here: Technical Model Webpage » ENVI-met Applications Homepage » Thermal Comfort Indices provided by BIO-met » Input Data Setup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
apps:biomet:quickstart3 [2023/06/01 15:05] – [Selecting the Spatial Range] enviadminapps:biomet:quickstart3 [2023/06/01 15:28] (current) – enviadmin
Line 62: Line 62:
 Please note, that all layers excluded from the BIO-met simulation will still be included in the generated output files. Hence, the spatial dimensions of the BIO-met output files are the same as the source ENVI-met model output, but model layers excluded from calculation will only hold "No Data" value data (-999,  [[filereference:edx_edi|see here]] ). Please note, that all layers excluded from the BIO-met simulation will still be included in the generated output files. Hence, the spatial dimensions of the BIO-met output files are the same as the source ENVI-met model output, but model layers excluded from calculation will only hold "No Data" value data (-999,  [[filereference:edx_edi|see here]] ).
  
-**For DynamicThermal Comfort, these settings have no impact as the approx. 1.6 m level will always be used for pedestrians.**+**For Dynamic Thermal Comfort, these settings have no impact as the approx. 1.6 m level will always be used for pedestrians.**
  
 <- apps:biomet:quickstart2|Quickstart^apps:biomet|BIO-met Home^apps:biomet:quickstart4|Final Steps -> <- apps:biomet:quickstart2|Quickstart^apps:biomet|BIO-met Home^apps:biomet:quickstart4|Final Steps ->