Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| using_leonardo [2012/07/07 01:21] – 134.93.180.188 | using_leonardo [2012/07/07 01:28] – 134.93.180.188 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Visualisation of ENVI-met Results using LEONARDO ====== | ====== Visualisation of ENVI-met Results using LEONARDO ====== | ||
| + | <fs smaller> | ||
| - | * [[Introduction]] | + | ===== Introduction |
| + | This document describes how to visualise // | ||
| + | |||
| + | This is a Step-by-Step guide showing how to display the ENVI-met files.\\ | ||
| + | Only a very few features of LEONARDO are presented here. You should also refer to the full LEONARDO manual included in your LEONARDO distribution.\\ | ||
| + | Unfortunately, | ||
| + | |||
| + | This document refers to the combination of LEONARDO 3.75+ and ENVI-met 3.1 data files.\\ | ||
| + | Due to memory restrictions, | ||
| + | \\ | ||
| + | \\ | ||
| + | ==== ==== | ||
| + | **Content: | ||
| * [[Step 1 - Getting started]] | * [[Step 1 - Getting started]] | ||
| - | * [[Step 2 - The DataNavigator]] | + | * [[Step 2 - Using the DataNavigator]] |
| - | * [[Step 3 - Fine-Tuning | + | * [[Step 3 - Fine-tuning |
| + | |||
| + | == == | ||
| + | * [[Data Layer]] | ||
| + | * [[Special Layer]] | ||
| + | * [[Vector Layer]] | ||
| + | * [[Isoline Layer]] | ||