Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
using_leonardo [2012/07/07 01:21] – 134.93.180.188 | using_leonardo [2012/07/08 22:12] – 134.93.180.188 | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Visualisation of ENVI-met Results using LEONARDO ====== | ====== Visualisation of ENVI-met Results using LEONARDO ====== | ||
+ | <fs smaller> | ||
- | * [[Introduction|Overview]] | + | ===== Introduction |
- | * [[Step 1: Getting started]] | + | This document describes how to visualise // |
- | * [[Step 2: The DataNavigator]] | + | |
- | * [[Step 3: Fine-Tuning | + | This is a Step-by-Step guide showing how to display the ENVI-met files.\\ |
+ | Only a very few features of LEONARDO are presented here. You should also refer to the full LEONARDO manual included in your LEONARDO distribution.\\ | ||
+ | Unfortunately, | ||
+ | |||
+ | This document refers to the combination of LEONARDO 3.75+ and ENVI-met 3.1 data files.\\ | ||
+ | Due to memory restrictions, | ||
+ | \\ | ||
+ | \\ | ||
+ | ==== ==== | ||
+ | **Content: | ||
+ | * [[Step 1 - Getting started]] | ||
+ | * [[Step 2 - Using the DataNavigator]] | ||
+ | * [[Step 3 - Fine-tuning | ||
+ | |||
+ | == == | ||
+ | * [[Data Layer]] | ||
+ | * [[Special Layer]] | ||
+ | * [[Vector Layer]] | ||
+ | * [[Isoline Layer]] |