Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
step_2_-_using_the_datanavigator [2012/07/07 03:27] – 134.93.180.188 | step_2_-_using_the_datanavigator [2012/07/08 22:06] – [Select Variables to Display] 134.93.180.188 | ||
---|---|---|---|
Line 25: | Line 25: | ||
This will tell LEONARDO to extract the selected variable out of the data file and put it on the selected layer (Pot. Temperature on Data Layer in this case) | This will tell LEONARDO to extract the selected variable out of the data file and put it on the selected layer (Pot. Temperature on Data Layer in this case) | ||
- | * [[Hint 1: Using ENVI-met defaults in LEONARDO]] | + | * [[Hint1|Hint 1: Using ENVI-met defaults in LEONARDO]] |
- | * [[Hint 2: Selecting the correct vector component]] | + | * [[Hint2|Hint 2: Selecting the correct vector component]] |
==== Select Type of Section ==== | ==== Select Type of Section ==== | ||
Line 46: | Line 46: | ||
==== Extracting Data and Build Map ==== | ==== Extracting Data and Build Map ==== | ||
After you have selected all variables to be imported into the map, you can extract the data from the ENVI-met file.\\ | After you have selected all variables to be imported into the map, you can extract the data from the ENVI-met file.\\ | ||
- | To extract a 2D cut, press the " | + | To extract a 2D cut, press the " |
{{ : | {{ : | ||
\\ | \\ | ||
\\ | \\ | ||
- | Next step: [[Fine tuning the map]] | + | Next step: [[Step 3 - Fine tuning the map|Fine tuning the map]] |