A holistic microclimate model

You are here: Technical Model Webpage » intro » ENVI-met Model Architecture

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
intro:modelconcept [2021/07/28 02:18] – enviadminintro:modelconcept [2021/12/10 17:54] – [Overview in a Nutshell] enviadmin
Line 12: Line 12:
   * Transpiration, Evaporation and sensible heat flux from the vegetation into the air including full simulation of all plant physical parameters (e.g. photosynthesis rate)    * Transpiration, Evaporation and sensible heat flux from the vegetation into the air including full simulation of all plant physical parameters (e.g. photosynthesis rate) 
   * Dynamic surface temperature and wall temperature calculation for each facade and roof element supporting up to 3 layers of materials and 7 calculation points in the wall/ roof.    * Dynamic surface temperature and wall temperature calculation for each facade and roof element supporting up to 3 layers of materials and 7 calculation points in the wall/ roof. 
 +  * Support of wall/ roof greening systems including substrate layer 
   * Water- and heat exchange inside the soil system including plant water uptake   * Water- and heat exchange inside the soil system including plant water uptake
   * 3D representation of vegetation including dynamic water balance modelling of the individual species    * 3D representation of vegetation including dynamic water balance modelling of the individual species