Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
apps:biomet:quickstart3 [2022/12/06 19:59] – [Selecting the Data Source] enviadmin | apps:biomet:quickstart3 [2023/06/01 15:03] – [Selecting the Data Source] enviadmin | ||
---|---|---|---|
Line 12: | Line 12: | ||
The complete output folder of a simulation contains a large set of different folders and data as described [[filereference: | The complete output folder of a simulation contains a large set of different folders and data as described [[filereference: | ||
- | //(For the biometeorological calculations in BIO-met V5.1, only the '' | + | |
+ | <WRAP center round info 60%> | ||
+ | For PMV, PET*, SET and UTCI only the '' | ||
+ | The '' | ||
+ | </WRAP> | ||
After selecting the root output folder, the content of the '' | After selecting the root output folder, the content of the '' | ||
Line 27: | Line 32: | ||
- | ===== Selecting the Time Range ===== | + | ===== Selecting the Time or Time Range |
- | After the output folder has been selected and read, the **Time Range** of the simulation must be set using the Data File Map. You can select a single file using the left mouse button, a set of single files by pressing SHIFT and the left mouse button or select a continuous time range by defining the first and the last time slice to be simulated. For the latter operation, right click the Data File Map graphics and select the required command. | + | After the output folder has been selected and read, the **Time** or the **Time Range** of the simulation must be set using the Data File Map. You can select a single file using the left mouse button, a set of single files by pressing SHIFT and the left mouse button or select a continuous time range by defining the first and the last time slice to be simulated. For the latter operation, right click the Data File Map graphics and select the required command. |
In the example below, we have selected a time range starting at 10:00 and ending at 20:00 hours of the first day. These two times plus all available time steps in between will be calculated in the simulation. | In the example below, we have selected a time range starting at 10:00 and ending at 20:00 hours of the first day. These two times plus all available time steps in between will be calculated in the simulation. | ||
Line 36: | Line 41: | ||
As additional information, | As additional information, | ||
+ | |||
+ | When working with the **Dynamic Thermal Comfort** tool, only a single time selection is required for which the simulation will be run. | ||
===== Selecting the Spatial Range ===== | ===== Selecting the Spatial Range ===== | ||
Line 57: | Line 64: | ||
- | <- apps: | + | <- apps: |