Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
filereference:output:pollutants [2021/11/11 20:08] – enviadmin | filereference:output:pollutants [2021/11/11 20:09] (current) – enviadmin | ||
---|---|---|---|
Line 12: | Line 12: | ||
Contains the pollutant data within the model area for every simulation output. Note that the pollutant data is only written if the model area includes sources. | Contains the pollutant data within the model area for every simulation output. Note that the pollutant data is only written if the model area includes sources. | ||
- | |||
- | If Water Spray is used, although modelled through a pollutant source, the outputs are stored in the [[filereference: | ||
- | |||
</ | </ | ||
+ | <WRAP clear></ | ||
+ | The pollutant data files are produced each main output interval (default: 60 min) and represent the general state and distribution of the pollutants at the given model time. | ||
- | <WRAP clear></ | + | If Water Spray is used, although modelled through a pollutant |
- | + | ||
- | The pollutant | + | |
<WRAP box left 99%> | <WRAP box left 99%> |