Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Last revisionBoth sides next revision
configuration_file [2012/06/30 14:06] 134.93.180.188configuration_file [2012/08/01 13:43] enviadmin
Line 14: Line 14:
 Each configuration file consists of a **basic information block** which must be included to run the model: Each configuration file consists of a **basic information block** which must be included to run the model:
  
-  * [[Basic Settings - The Minimal Configuration File]]+  * [[Basic Settings|Basic Settings - The Minimal Configuration File]]
  
 In addition, different "**sections**" can be added to the configuration. Each section begins with a keyword (e.g. „''[SOIL]''") followed by the settings.  In addition, different "**sections**" can be added to the configuration. Each section begins with a keyword (e.g. „''[SOIL]''") followed by the settings. 
  
-  * [[Overview of all Sections in ENVI-met 4.0]]+  * [[Sections|Overview of all Sections in ENVI-met 4.0]]
  
 Sections allow to overwrite default values of ENVI-met. Some sections will probably be included in each of the .CF files, some of them seldom or never. If a section is not included in the .CF file, the default values (shown in brackets behind the entries) are used. Sections allow to overwrite default values of ENVI-met. Some sections will probably be included in each of the .CF files, some of them seldom or never. If a section is not included in the .CF file, the default values (shown in brackets behind the entries) are used.
Line 26: Line 26:
 \\ \\
  
-=== Important Notice for users of Version 2.x: === 
  
-//From Version 3.1 on, the following information have been moved from the configuration files into the area input files, where they are better placed: 
- 
-  * the rotation information   
-  * the number of nesting grids  
-  * the type of soil for the nesting area  
-  * the location on earth (position) 
-  
-Therefore the sections [ROTATION], [NESTING] and [POSITION] do not exist any longer in the model!//